How to better my signal using an amplifier or attenuator

A televisionsignal amplifier can help improve a weak signal, especially in areas that do not have good televisioncoverage. It is also useful for distributinga signal to many televisions. In contrast, an attenuator can reduce a signal if it is too strong.

Both these devices should only be used when necessary. In manycases a good aerial installation with good quality cables can be enough to receive good reception.


When to use an amplifier

A signal amplifier should only be used as a last resort when the televisionsignal is weak. Even the best amplifier will still add some noise to the television signal it is amplifying/boosting that could result in picture break up. A good amplifier should have a filter built in that only allows the signal you want to be boosted and not any unwanted signals. Otherwise, all the unwanted signals will also be boosted, which can causepictures to break up.

Problems using amplifiers

Amplifiers themselves are a common source of reception problems. For example, if water were to get into a masthead type, they can start to boost the result of the fault. This could be unwanted signals and result in picture loss on your own television and, maybe, those living nearby. To check, remove the power from the amplifier and see whether the problemgoes away.

There are three types of amplifier– masthead, set-back and distribution. Allthese need a power supply to work.

Masthead

These fit directly under an outside aerial and usually the best type of amplifier to fix weak signals.

Set-back

These fit between the aerial socket in the wall and your television.

Distribution

These split the TV signal from a single aerial and allow the signal to be sent to several different televisions in the building.

amplifiers
Masthead, Set-back and distribution amplifiers

Combined amplifiers

Some amplifiersare a mix of the above. For example, some masthead amplifiers are also distribution amplifiers. Some can also combine television and FM radio signals.

Attenuators

When to use an Attenuator

If you are experiencing pixellation or picture break up, it may be that your signal is too strong as this often presents itself similarly to a weak signal. This is likely to happen if you live close to a transmitter.

Attenuators can be used to decrease the incoming signal if it is too strong without distorting it. It is effectively the opposite of an amplifier, though the two work by different methods. While an amplifier provides gain, boosts the signal, an attenuator provides loss, reduces the signal. Attenuators are always a compromise and should only be used if absolutely necessary.

They come in a variety of powers; in most cases a small reduction is all that is needed. It may take a little trial and error to find the most suitable one for your installation, and it is worth taking the advice of a local aerial contractor to select the correct one for the installation.

Attenuator